1L Concrete and Pavement Rust Cleaner

Overview

Concrete & Pavng Stone

• For paving stones and concrete
• Will quickly and effectively remove rust stains with minimal etching or discolouration to the surface DIRECTIONS:
• Note: This cleaner will remove efflorescence as well as rust; rust stains removed from (non coloured) natural concrete that is white with efflorescence, will exhibit concrete's natural grey shading where the stain was removed; to avoid this appearance on white concrete, clean the entire surface with Rust Cleaner
• (Step 1) Do not apply in direct sunlight; never allow product to dry on surface until fully rinsed; pre-wet stained area and all areas below stain with water; apply a liberal amount of rust cleaner to the stained areas only and allow to stand until rust colour is visible on surface of foamed cleaner (approximately 20 seconds); scrub with nylon bristle brush and rinse thoroughly
• (Step 2) Clean entire surface with Concrete Cleaner & Surface Prep; thoroughly rinse all cleaners with generous amounts of water and ensure the surface is completely dry prior to applying sealer; we strongly recommend following all instructions prior to any sealant application
• (Step 3) Seal the surface with the appropriate sealer WARNING:
• Do not mix with oven cleaners, bleach or other household chemicals; do not swallow; do not get in eyes; do not get on skin or clothing; do not breathe fumes; handle with care; keep out of reach of children; wear a NIOSH-approved respirator; wear rubber gloves and safety goggles; use only in a well-ventilated area FIRST AID TREATMENT:
• Contains Phosphoric acid and Nonyl phenol ethoxylate; if swallowed, call a Poison Control Centre or doctor immediately; do not induce vomiting; if in eyes, rinse with water for a least 15 minutes; if on skin, rinse well with water; if on clothes, remove clothes; if breathed in, move person to fresh air

Overview