3.78L Low VOC Concrete Sealer

Overview

Concrete & Pavng Stone

• For stamped or slab concrete
• Restores & enhances colour
• Easy to apply, dries in minutes
• Gives wet look & wears evenly
• Protects your concrete against harsh pool chemicals, colour fading UV rays, dirt, salt, acid rain, grease, oil and rust penetration
• Protects new surfaces and makes old concrete look new again by dramatically enhancing existing colours
• Will darken white slab concrete DIRECTIONS:
• For new installations, wait a minimum of 30 days for concrete to cure prior to cleaning and sealing applications; (Step 1) remove all stains with the appropriate Stonesaver stain cleaners; (Step 2) clean the entire surface with Stonesaver Concrete Cleaner & Surface Prep to remove efflorescence, dirt and tire tracks from surface pores (Do not use the Surface Prep cleaner on new unsealed stamped concrete surfaces as it will remove the release agent and any two tone effects; Only power wash lightly); proper cleaning will enhance your concrete's true colours and allow for proper sealer to surface bonding; thoroughly rinse all cleaners with generous amounts of water and ensure the surface is completely dry prior to applying sealer; following all instructions prior to any sealer application is strongly recommended; (Step 3) for best results, use an airless sprayer or a lint-free high pile roller and a metal paint tray to apply Stonesaver Concrete Sealer; surface must be fully dry (usually 24 hours after cleaning); apply at temperatures above 7degrees C (45 degrees F); apply sufficient sealer to fully saturate the surface; wait 2 minutes, use a dry roller and roll up any pooled sealer from impressions in the concrete surface; for surfaces being sealed for the first time, apply a second coat in a cross direction to the first coat; again, roll up any pooled sealer; apply second coat immediately; allow sealed surfaces to dry for 24 hours before using COVERAGE:

Overview