300mL Wet/Dry Plastic Cement

Overview

Wet Patch Roof Cement

• Is a sealer and filler for use in patching cracks and breaks in roofing surfaces, firewalls, chimneys, gutters, flashing, etc., particularly in emergency situations where the stopping of a leak from a wet surface must be done
• It is ideal for patching and roof maintenance, sealing and repairing shingle tabs, flashing, roof seams and gable joints
• It can be used to stop leaks around vent pipes, spouts and gutters and is suitable for sealing metal building seams, foundations, masonry steps or in repointing chimneys ADVANTAGES:
• Versatile - use on dry or damp surface
• Waterproof - forms a tight, strong seal; stays soft and pliable
• Easy to use - apply using a standard caulking gun PREPARATION:
• Remove dust, dirt and debris using stiff brush or broom
• Remove crusted rust or scaled previous coating by scraping or wire brushing APPLICATION:
• When application is to take place at temperatures below 50'F (10'C), store it at room temperature for 24 hours prior to use in order to make gunning easier
• Cut spout to desired bead size and puncture inner seal
• Using a standard caulking gun, apply directly over area to be sealed
• May be tooled with a trowel or putty knife
• Occasionally dipped in paint thinner
• Tools and hands should be cleaned with paint thinner or mineral spirits
• Cannot be painted
• Emergency repairs to wet surfaces should be considered temporary and should be redone, if needed, when weather conditions improve COVERAGE:
• 1/4" by 1/4" bead will cover 25 lineal feet per 300ML cartridge SPECIFICATIONS:
• Flash point: 38'C (100'F)
• Viscosity @ 80'F (ASTM D217): 275-335
• Non-volatile (Fed. Test Method 141): 70% min. by weight
• Specially processed bitumen: 30% min.
• Total solids, by volume: 65% min.
• Dry film thickness 1gal/15sq.ft: 75 mils
• Drying time: 2 to 3 days
• Service temperature, ext. exposure: -28'C to +65.5'C
• Resistance to oils and

Overview