3.78L Clear Roof Coating

Overview

"Through the Roof" Roof Coating

• The clear, flexible, caulk that permanently seals around rooftop fixtures
• Will not turn brittle in the sun or cold
• Waterproof - repels water immediately after application and for years to come
• It's clear, which means you can put it over tile, brick, and shingles invisibly
• Won't blacken the look of rooftop fixtures
• Excellent UV resistance
• Lasts 2-3 times longer than asphalt roof sealants
• Will twist, bend, stretch over gaps up to 2" wide, or compress to absorb just about any movement a home can dish out
• Clear synthetic rubber-based product contains no fillers or extenders and is not an asphalt
• Cures by solvent release to an elastic rubber ADHERES TO:
• Galvanized metal and aluminum flashing vents, downspouts, copper and brass
• PVC and ABS vent pipe
• Neoprene and plastic pipe flashing
• Brick, block and mortar
• Acrylic and polycarbonate skylight plastics
• Roofing Materials Fiberglass / asphalt shingles
• Cedar shakes, plywood and OSB
• Water-based acrylic roof coatings
• Cement, slate and glazed tiles
• Asphalt roof cement and patch (may become discolored when applied over these products)
• May damage polystyrene insulation
• Do not use in areas of continuous submersion such as fish tanks or swimming pools
• Should not be used on RV roofs and EPDM PREPARATION:
• Clean surfaces by removing all dirt and oil, and cutting away any loose roofing material
• Surfaces previously sealed with silicone caulks should be cut away if possible or surfaces cleaned thoroughly with acetone solvent to get good adhesion as silicones can leave oils that interfere with adhesion TOOLS NEEDED:
• Foam or course bristle brush, rag WEATHER GUIDLINES:
• In colder weather (below 40 degrees F), storing product at room temperature before application will make it easier to use
• May be applied to wet surfaces however, repairs made when the roof is dry are usually better
• May not be appl

Overview