3.78L Roof and Foundation Coating

Overview

Non Fibrated Foundation Coating ROOF:

• This coating is excellent as a primer and re-saturant for all weathered built-up roofs before applying fibered roof coating
• It is also recommended for use on metal surfaces, such as metal roofs, gutters, spouts, tanks and other structural iron for protection against rust and other water damage
• It is able to resist weather, acid and alkali
• It is not recommended for use on tar roofs FOUNDATION:
• These products are used to coat exterior below-grade walls and abutments
• They can be used on concrete, brick or tile foundation walls
• Properly applied, they give adequate protection for an indefinite period, providing a damp-free foundation that combats mildew, rust, mould and rot
• They are smooth, homogeneous blends that will not separate or settle
• For exterior use only
• Not to be used indoors under any circumstances ADVANTAGES: ROOF:
• Low viscosity coating penetrates, resaturates and revitalizes dry but sound roofing felts, extending their life expectancy
• Waterproofs - provides a barrier against moisture and weather
• Economical - high coverage rate FOUNDATION:
• Versatile - 3 grades of product to meet any application
• Durable - provides a thick waterproofing coating on all masonry surfaces
• Easy to use - no stirring required, will not run or sag PREPARATION: ROOF:
• Sweep off all dust, dirt and debris
• Roof should be completely dry before applying coating
• Repair all cracks, breaks or open seams with Black Jack 6225 Excel Wet/Dry Surface Plastic Cement and allow to dry at least overnight before coating FOUNDATION:
• Surfaces must be clean and free of all foreign matter
• Do not apply on damp or frost-covered surfaces
• Fill cracks
• All pores of the surface must be filled with coating, leaving no voids, to ensure a proper seal APPLICATION: ROOF:
• Apply with roofing brush, paint brush, mop or spray equipment, depending on

Overview