STONESAVER Concrete & Paving Stone Cleaner & Surface Prep - 1 L

Stonesaver Concrete Cleaner and Surface Prep is an easy to use product that cleans dirt, white salt deposits and tire tracks that will not harm your concrete or paving stone surfaces. Use of this material will ensure proper sealer to surface bonding and does not contain muriatic or hydrochloric acids which can damage concrete surfaces. Application is made easy with the auto-diluting E-Z Sprayer.

• Cleans dirt, efflorescence & tire tracks
• Will not harm concrete surfaces
• Ensures proper sealer to surface bonding
• Easy to use with auto-diluting E-Z Sprayer
• Formulated to remove efflorescence (white salt deposits), dirt and tire tracks from your paving stone and concrete surfaces
• Contains no muriatic or hydrochloric acids which can damage concrete surfaces
• The proper removal of dirt and efflorescence is imperative to ensure sealer to surface bonding and enhance the surface colour prior to sealer application
• Comes complete with the "E-Z Sprayer" water hose end adapter, which automatically dilutes and disperses this highly concentrated cleaner at a ratio of 20 parts water to 1 part cleaner which eliminates chemical mixing procedures and the need for costly professional equipment or the inconvenience of using heavy jug dispensers

• (Step 1) Remove all stains with the appropriate Stonesaver stain cleaners
• (Step 2) Simply attach your water hose to the inlet port of the E-Z Sprayer and you are ready to start; always pre-wet the surface with water before each application of Stonesaver Cleaner & Surface Prep; working quickly, start at the lowest point of your surface and work in 27 sq. m (300 sq. ft.) pre measured sections; work side to side, making sure the entire surface is covered; if there is still cleaner remaining in the bottle after the 300 sq. ft. section has been covered, apply the remaining cleaner as an additional spray over the same area; this will reinforce the cleaning application and prevent drying of the surface; use a long handled stiff bristled broom to brush the treated area, loosening stubborn dirt and deposits; rinse thoroughly (usually 5 - 6 rinses with 2 water hoses) until foaming is no longer visible; be sure to rinse all cleaner from the surface as you progress to additional sections until the entire surface is cleaned and thoroughly rinsed; do not let cleaner dry on surface; an additional water hose will facilitate rinsing; mist surface with water if it begins to dry while cleaning; when the entire surface is cleaned and well rinsed, allow to dry and inspect; repeat application to any white areas if necessary
• (Step 3) Seal the surface using the appropriate Stonesaver sealer

• If used in accordance with supplied directions; 1 litre/1 Quart covers a maximum 27 sq. m (300 sq.ft.)
• Do not mix with oven cleaners, bleach or other household chemicals; do not swallow; do not get in eyes; do not get on skin or clothing; do not breathe fumes; handle with care; keep out of reach of children; wear a NIOSH-approved respirator; wear rubber gloves and safety goggles; use only in a well-ventilated area

• Contains Phosphoric acid, Sulfuric acid and Sodium dodecyl diphenyloxide disulfonate; if swallowed, call a Poison Control Centre or doctor immediately; do not induce vomiting; if in eyes, rinse with water for a least 15 minutes; if on skin, rinse well with water; if on clothes, remove clothes; if breathed in, move person to fresh air

Our Return Policy

If you are not completely satisfied with your purchase, in most cases, you can return it for a refund within 90 days.

Lumber, Building Materials, Furniture and Major Appliances return policies are subject to your local store.

Learn More