IBERVILLE 2-1/4" Non-Gangable Rework Switch Box

To install a device into an existing wall.

• Installed from the front of the drywall (for retrofit installation)
• Swing-arm rework brackets
• Maximum wall thickness: 3/4"
• 3" x 2" x 2-1/4" deep
• Flush ears
• One 1/2" bottom knockout
• 4 pryout ends

• Using the template supplied with each box, trace the box pattern on the desired location
• Cut opening using the traced lines
• Remove the pryout from the box, pull thru the cable and tighten the cable clamp
• Insert the box into the cut-out while holding the "Swing-arm" against the sides of the box
• Turn both "Swing-arm" tightening screws (This will cause the "Swing-arm" holding device to turn to the proper position and then tighten itself against the back face of the drywall)

Our Return Policy

If you are not completely satisfied with your purchase, in most cases, you can return it for a refund within 90 days.

Lumber, Building Materials, Furniture and Major Appliances return policies are subject to your local store.

Learn More